AFM Safecoat Ecolacq Sandable Primer

USE ON:

Unfinished (or properly prepared and sanded previously finished) wooden cabinetry, doors, paneling, furniture, and wood railings.

LIMITATIONS:

AFM Safecoat Ecolacq Sandable Primer is made without formaldehyde preservatives. Do not contaminate. Store in airtight containers. Do not use when indoor temperature is below 55 degrees F. Do not freeze. Thick application, high humidity or conditions other than normal will cause Safecoat to dry and cure more slowly.

COVERAGE:

One gallon covers approximately 350 square feet. One coat is sufficient for most jobs.

APPLICATION

• • • Always have adequate ventilation. Before using, gently stir or roll container to avoid air bubbles. Be sure to stir product thoroughly every 20 minutes during application. Pour AFM Safecoat Ecolacq Sandable Primer to be used into another container before applying coating to avoid contaminating main container.
    • Apply using a quality nylon brush, pad applicator, or unheated spray applicator.
    • Apply even coats, keeping a good wet edge and avoid over-brushing. When spraying, use a .015 tip or smaller. Apply thin even coats when spraying rather than heavy coats which will tend to sag. If spray pattern begins to dryspray, reduce air pressure and increase material flow to surface. Use aluminum oxide or silicon carbide sandpaper to sand between coats. For best results, this product should not be reduced. Use only during low or moderate humidity conditions.

DRYING/CURING TIME:

Under normal conditions, AFM Safecoat Ecolacq Sandable Primer is sandable and recoatable after 4-6 hours. Normal conditions include a dry surface, access to fresh airflow, cure and become harder over time.

IMPORTANT: Thick application, high humidity or conditions other than normal will cause Safecoat to dry and cure slowly.

CLEAN-UP:

Clean tools and equipment while still wet with a solution of SafeChoice Super Clean and warm water.