AFM Penetrating Waterstop

Safecoat Penetrating WaterStop is a zero voc, non-film forming sealer designed to improve water resistance and repellency in a wide variety of surfaces, including brick walls, concrete foundations, stucco, stone and most unglazed tile. It is not toxic and low odor, making it non-offensive to installer and occupant. It can be used indoors instead of a typical high solvent content sealer and is durable enough for use outdoors.

USE ON:

Porous, mineral containing surfaces such as brick, pavers, concrete block and other cementitious materials, stone and stucco. Not suitable for wood.

ADVANTAGES / SIGNIFICANT BENEFITS:

• • • Good water resistance for up to five years when properly applied.
    • Low odor, non-offensive to installer and occupant.
    • Safely used by and for the chemically sensitive.
    • Fights indoor air pollution
    • Zero VOC content, meets or exceeds all federal and state air quality regulations, including California.
    • Contains no formaldehyde.

COVERAGE:

Most surfaces, 200-300 square feet per gallon. Natural limestone, 300-500 square feet per gallon. Coverage can depend on substrate porosity.

APPLICATION:

Safecoat Penetrating WaterStop with a brush or spray equipment in an even and uniform manner. Do not use a roller. For vertical surfaces start at the top and work down. Keep a wet edge. Always test a sample for suitability prior to full use. Avoid puddling on horizontal surfaces. Apply one coat only. Do not dilute. Note: these instructions are intended to be general only and not exhaustive. The applicator should determine which preparation and techniques are best suited to the specific surface.

CLEAN-UP:

Clean tools and equipment while still wet with a solution of SafeChoice Super Clean and warm water.

DRYING/CURING TIME:

24 hours full cure in moderate humidity and heat.